Changing a flat tire in Spokane, WA is an essential skill that every driver should know. A flat tire can happen at any time, and it’s important to be prepared. Here are the basic steps for changing a flat tire:
1. Find a safe location to change the tire: Pull over to a level and stable area, away from traffic. Turn on your hazard lights and engage your parking brake.
2. Get your tools and spare tire: Locate your jack, lug wrench, and spare tire in your vehicle’s trunk or undercarriage. Make sure they are all in good condition and working order.
3. Loosen the lug nuts: Use your lug wrench to turn the lug nuts counterclockwise, but don’t remove them yet.
4. Lift the vehicle with the jack: Look for the jacking point in your car’s owner’s manual or the car itself. Place the jack under this point and lift the vehicle until the flat tire is off the ground.
5. Remove the lug nuts and tire: Once the lug nuts are loose, remove them completely, and take off the flat tire.
6. Install the spare tire: Line up the spare tire with the studs and hand tighten the lug nuts before using the wrench to tighten them further.
7. Lower the vehicle and tighten the lug nuts: Lower the vehicle with the jack and remove it. Use the wrench to fully tighten the lug nuts in a star pattern to ensure even distribution.
8. Check the tire pressure: Make sure the spare tire is inflated to the correct pressure, which can be found in the owner’s manual or on the sidewall of the tire.
9. Finally, double-check: Before driving away, make sure the lug nuts are secure and the spare tire is installed properly.
By following these steps, changing a flat tire can be a simple and easy process. Remember to always stay safe and be prepared when driving on the road.
Remember to Call Spokane Towing if you need any help with tire changes!