Spokane Flat Tire Assistance

Getting a flat tire in Spokane, WA can be stressful and inconvenient, but it’s important to know how to handle the situation. Knowing what to do when you get a flat tire can save you time, money, and stress. In this guide, we will go over the steps you should take when faced with a flat tire.

Step 1: Pull Over in a Safe Location

The first thing you should do when you realize that your tire is flat is pull over in a safe location. This could be on the side of the road or in a nearby parking lot. Make sure that you are not blocking traffic and that your car is as far away from moving vehicles as possible.

Step 2: Turn on Your Hazard Lights

Once you have pulled over, it’s important to turn on your hazard lights. This will alert other drivers that there is an issue with your vehicle and that they should proceed with caution.

Step 3: Gather Necessary Tools and Equipment

Before you start changing the tire, make sure you have all the necessary tools and equipment. This includes a spare tire, jack, lug wrench, and any other tools specific to your car model. If you are unsure about what tools you need, consult your car manual or call for roadside assistance.

Step 4: Loosen the Lug Nuts

Use the lug wrench to loosen the lug nuts before lifting the car with the jack. Do not remove them completely, just loosen them enough to make it easier to take off once the car is lifted.

Step 5: Lift the Car with the Jack

Place the jack under your car’s frame near the flat tire and start lifting. Make sure that you are using a solid and level surface to avoid any accidents.

Step 6: Remove the Lug Nuts and Flat Tire

Once your car is lifted, remove all of the lug nuts and keep them in a safe place. Then, carefully remove the flat tire from its position.

Step 7: Install the Spare Tire

Take your spare tire and line it up with the lug bolts on your vehicle. Once it is secure, start tightening the lug nuts by hand.

Step 8: Lower the Car and Tighten the Lug Nuts

Using the jack, lower your car until it is resting on the ground. Then, use the lug wrench to tighten the lug nuts as much as possible.

Step 9: Check Your Tire Pressure

After changing your tire, it’s important to check its pressure. If necessary, use a tire gauge to ensure that your spare tire has enough air.

Step 10: Get Your Flat Tire Repaired or Replaced

Although you may be able to temporarily fix a flat tire with a patch kit, it is recommended to get it properly repaired or replaced as soon as possible. This will ensure that your vehicle is safe and ready for future drives.

For that Contact us at Spokane Towing!